Effortless and cost-free I/O extension
The ioLogik E1200 remote Ethernet I/O series has gained a powerful new peer-to-peer communications technology that enables reproduction of I/O signals and extended data transmissions over Ethernet. The ioLogik E1200 I/O module can now connect I/O sensors to the ioLogik E1200 output module over copper, fiber, or wireless Ethernet infrastructure to achieve tremendous savings on cabling and wiring. With this technology, digital and analog signals can be duplicated over virtually unlimited distances with no host PC, PLC, or controller needed, and without any noise interference.
Easy and effective cable replacement
The enhanced ioLogik E1200 can replace cables by integrating many I/O signals over a single network cable to transmit input-to-output controls without any involvement from PLCs or controllers. All the I/O signals can travel intact through Ethernet and be reproduced at the destination device.
Internet-friendly multiple-target transmission
Since peer-to-peer communication supports channel-to-channel
mapping, the ioLogik E1200 allows simultaneous multiple
target transmission, and also supports up to 16-channel
transmission over Ethernet, based on an emitter and receiver
I/O pair. Moreover, destination socket ports can be specified
individually for each channel map. This technology creates
high flexibility if the remote ioLogiks are installed behind
a router or firewall.
Safe mode protection from network failure
For output control, the output device can use “safe mode” configuration to help detect network failures. This preventive function prompts the output ioLogik to display a warning flash when the network disconnects. The output will then return to the latest signal status, or be set to a preset value, depending on the configuration.
Daisy chain connectivity with simple wiring
The ioLogik E1200's two Ethernet ports come with a built-in
switch that enable daisy chains of multiple network devices.
A daisy-chains is a simple architecture that is easy to
wire and maintain. The cascading connections can easily
create the multi-drop I/O networks that are commonly used
for factory automation, security and surveillance systems,
tunnel monitoring, and other industrial applications. The
two Ethernet ports can alternatively be used to construct
a backup link to ensure network redundancy and stability.
Seven Times Faster than other SCADA Integration Solutions
The ioLogik E1200 supports push-based Active OPC Server
to achieve faster communication with SCADA systems. With
Moxa's free Active OPC Server software, the ioLogik E1200
uses event driven "active tags" to deliver instant
I/O status reports to SCADA systems seven times faster than
other OPC Server packages, and reduces network traffic by
80%.
|
 |
 |
 |
Peer-to-peer data regeneration to extend I/O transmissions |
 |
|
Built-in 2-port Ethernet switch for daisy-chain topology |
|
|
Push-based Active OPC for seamless SCADA connection |
|
|
7 times faster in I/O response time |
|
|
80% bandwidth savings for SCADA network traffic |
|
|
User-defined Modbus/TCP addressing |
|
|
MXIO programming library for Windows/WinCE VB/VC.NET and Linux C APIs |
 |
