| Add-on Advantages |
 |
Provides Peer-to-Peer control over Ethernet for direct input-to-output signal communication |
| |
Distributes I/O signal to multiple locations without requiring PC, PLC, or any programming |
| |
Extends I/O signals over existing copper, fiber or wireless Ethernet infrastructure |
| |
Reduces cabling costs |
| |
Provides solution for areas where physical wiring is difficult or impossible |
Introduction
|
Peer-to-Peer I/O Command is the latest feature of the ioLogik E2000 Active Ethernet I/O series and provides direct I/O signal communication over Ethernet. The new feature uses two Active Ethernet I/O servers to instantly exchange sensor input/output signals over Ethernet without requiring a PLC, PC controller, or extra wiring.
|
| Requires no controller, less wiring |
| The patented Click&Go™ software on Active Ethernet I/O servers uses an intuitive If-Then interface for logic control without any programming effort. Even with beginners, just a few minutes of configuration are required and all devices are set and ready to go.
Applications:
-Tank level monitoring / pump controls and monitoring
-Remote switching panel system
-Alarm system
-Signal distribution system
-and more...
Benefits:
-Cuts down overall hardware costs
-Allows logic control with no programming
-Reduces maintenance effort
-Extends signals over long distances
-Quiet operation
-Easy configuration
|
Availability
Peer-to-Peer I/O control is available by upgrading the firmware and Windows utility for ioLogik E2210 and E2240 models. The new firmware and utility will be available in December.
|
| Top |
