Taipei, Taiwan, June 23, 2008—Moxa is pleased to announce the grand launch of our Active Ethernet I/O family, the ioLogik E2214/E2242/E2262. These devices provide multiple I/O combinations and are ideal for remote monitoring and alarm applications. The ioLogik E2214/E2242/E2262 all feature Moxa's patented Click&Go™ logic, which uses a simple and intuitive "If-Then" logic to configure events without need for programming. Instead of using the traditional passive polling structure, the ioLogik E2214/E2242/E2262's "report by exception" function actively sends an instant event message to the control room via TCP/UDP/e-mail/SNMP trap when user-defined I/O conditions have been satisfied. This feature not only conserves network bandwidth but makes local control easier as well.

The ioLogik E2214 is a stand-alone Active Ethernet I/O product with 6 digital inputs and 6 relay outputs. The ioLogik E2214 is designed to record counts with its built-in relay outputs and can be connected to digital switches, alarm lights, buzzers, and warning sirens over Ethernet and IP-based networks. In the event of a power failure, the ioLogik E2214 is able to record final counts before power is fully down, making it suitable for high voltage applications, such as facility management, building automation, security systems, and home automation.

To provide the best fit for remote monitoring and alarm systems, the ioLogik E2242 comes with 4 analog inputs and 12 configurable DIOs built-in. The I/O combination provided by the ioLogik E2242 allows one analog input channel to trigger up to 3 digital outputs, such as local High-High, High, and Low alarms, without the use of a local PC or RTU. Furthermore, applications such as remote monitoring for fire, intrusion detection, power supply status, oil tanks, etc., can now be done with a single analog/digital mix I/O module.

The ioLogik E2262 is an 8 thermocouple input and 4 digital output Active Ethernet I/O product that can extend the length of your sensors' wiring by a factor of 10. For example, the usual length of a J-Type sensor is 10 meters, but the ioLogik E2262 can accept 100 meters of J-Type TC wiring. Furthermore, the ioLogik E2262 has two sets of cold junction compensation and digital filtering. Calibration, linearization and calculation are based on the devices traced by NIST (National Institute of Standards and Technology) and stored in the memory to eliminate these factors as a potential source of error. The ioLogik E2262's temperature module is also well suited for wider range temperature applications like facility automation, HVAC, heating systems, and boiler systems.